"
Keyboard

How To Reconnect A Laptop Keyboard Ribbon Cable Locking Clip Connector!?

The connector is a very delicate mechanism. It’s very easy to get it damaged if you apply too much force while trying to unlock it.

Đang xem: Laptop keyboard ribbon cable

The cable retainer (locking clip) is made of thin plastic and if it’s damaged, you are in trouble. Unfortunately, this part is not sold separately.

Well… let’s say it happened. The damage is done. How to fix it now?

On the picture below I show one of the most common connector types. It has the base (white in my case) and cable retainer (brown in my case).

When the connector is closed, the cable secured between the retainer and base.

The retainer applies some pressure on the cable and it makes contact with the pins inside the connector.

To unlock it properly, you have to move the retainer about 2 millimeters in the direction shown by two yellow arrows.

IMPORTANT! The retainer must remain attached base.

After that you can pull the keyboard cable and remove the keyboard.

*

If you are not careful enough, you can move the retainer too far and break it.

On the picture below you can see the retainer broken on both sides. It is missing the both locking hook.

*

IMPORTANT! Do not though away the retainer. You still can use it.

The cable will not stay inside the connector without the locking clip.

*

Here’s how fix this type of damage.

Position the broken piece the way it was inserted before.

*

Carefully insert the cable into the connector. In this case the cable goes above the retainer.

See also  Asus Laptop Keyboard Problems

Xem thêm: Solved: Nike Running App Music ?: Nikerunclub : Nikerunclub

*

While holding the cable, carefully push the broken clip back in place. You can use a small screwdriver for that.

The clip fits tightly into the connector even though it has two broken hooks.

*

Secure the connection with sticky tape and test the keyboard. It should work just fine.

*

Here’s another connector type. The only difference – the keyboard cable is routed under the locking clip. Fix it the same way as the previous connector.

*

On the next picture you see another type of connector. The cable is inserted vertically.

*

In order to unlock the connector, you’ll have to move the locking clip (brown piece) about 2 millimeters up in the direction shown by two yellow arrows.

After that you can pull the keyboard cable (green arrow) and remove the keyboard.

*

If you move the locking clip too far, you can break it.

In my example one side of the retainer got damaged.

*

Insert the keyboard cable into the connector, position the broken retainer correctly (behind the cable in my case) and carefully push it in.

Even with a broken retainer the cable should be secured inside the connector.

*

Here’s the same connector shown from the opposite side. You cannot even tell it is broken.

Xem thêm: Build Your Own Pitching Machine Schematics, How To Make A Pitching Machine

*

If this trick worked for you, it means I just saved you big bucks on the motherboard replacement. And I’m glad I did.

REPAIR TIPS FROM READERS:

Thank you to Alex for the following suggestion:

See also  Download Microsoft Keyboard 2000 Driver Download 2021 Version

I found another way to fix it…Have you lost the broken “Locking clip”?Then do this…Get some “electrical tape” on the back of the “flat cable” to make some “thickness”.Make sure you are putting the tape on the right side, where there are no visible connections…

Then very carefully push the cable into the connector… It will not come loose and the keyboard will work just fine!

See more articles in category: Keyboard

Leave a Reply

Back to top button